MacDon M205 Operators Manual - Manual (Page 108)

OPERATOR’S STATION
4. Press right (B) arrow to select Yes. Press SELECT (C).
• TO CALIBRATE SELECT is displayed in upper line.
5. Press left (A) or right (B) arrow until HEADER HEIGHT
is displayed on the lower line. Press SELECT (C).
• CALIBRATING HEIGHT is displayed on the
upper line.
• RAISE HEADER HOLD is displayed on the
lower line.
Figure 3.84: Selecting Header Height
Calibration
CAUTION
Check to be sure all bystanders have cleared the area.
6. Press and hold the HEADER UP (C) button on the
ground speed lever (GSL).
• CALIBRATING HEIGHT is displayed on the
upper line.
• RAISE HEADER HOLD is displayed on the
lower line.
NOTE:
The word HOLD will flash during calibration. RAISE
HEADER DONE will display on the lower line once
calibration is complete.
7. Release the HEADER UP (C) button.
• HEIGHT SENSOR CAL is displayed on the
upper line.
• PRESS LOWER HEADER is displayed on the
lower line.
Figure 3.85: Header Height Controls on Ground
Speed Lever
169887 92 Revision A