MacDon M205 Operators Manual - Manual (Page 154)

OPERATOR’S STATION
Testing the Reel Drive Circuit using the Cab Display Module (CDM)
IMPORTANT:
Do not over speed a drive for a significant length of time. Doing so can lead to vibration, belt failures, or
other over speeding related problems.
NOTE:
• Header MUST be attached to windrower to follow this procedure. For more information, refer to 4.5 Attaching
and Detaching Headers, page 202 .
• This procedure does not apply to rotary disc headers.
• Engine MUST be running to perform this procedure.
1. Start the engine.
Refer to Starting the Engine, page 152 .
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
Figure 3.192: CDM Programming Buttons
3. Press SELECT (B) until DIAGNOSTIC MODE? is
displayed in upper line.
• NO/YES is displayed on the lower line.
4. Press right (A) arrow to select Yes. Press SELECT (B).
Figure 3.193: Selecting Diagnostic Functions
169887 138 Revision A