MacDon M205 Operators Manual - Manual (Page 215)

OPERATION
Using the Auto Raise Height Feature
IMPORTANT:
The windrower must be running with the header engaged
at the cutting height and the RETURN TO CUT switch
(A) activated.
Use the AUTO RAISE HEIGHT feature as follows:
1. To raise the header to the AUTO RAISE HEIGHT
set point, double-click (two clicks within 0.5 seconds)
the HEADER UP switch (B) on the ground speed
lever (GSL).
NOTE:
With AUTO RAISE HEIGHT turned ON, the
ACRE counter will be disabled when header
height greater than preset cutting height.
2. If desired, press HEADER UP switch while header is
being raised to disable AUTO RAISE HEIGHT and
maintain current height.
NOTE:
With AUTO RAISE HEIGHT turned OFF, the
ACRE counter will be disabled when header
height value is greater than 9.5. OFF is displayed
on the cab display module (CDM).
3. To return the header to the preset cutting height,
momentarily press HEADER DOWN switch (C).
Figure 4.90: Operator’s Station
4.4.9 Header Drop Rate
The header should lower gradually when the HEADER DOWN switch is pressed. From full height to ground should
take 3–4 seconds.
If the drop rate requires adjustment, refer to Adjusting Header Drop Rate, page 389 .
169887 199 Revision A