MacDon M205 Operators Manual - Manual (Page 394)

MAINTENANCE AND SERVICING
Turn Signal Indicators
If the turn signal indicators on the cab display module (CDM) do NOT function, contact your MacDon Dealer.
Accessing Circuit Breakers and Fuses
The circuit breakers and fuses are located inside a fuse box mounted on the right (cab-forward) side of the
frame under the platform.
The circuit breakers automatically reset. Fuses are the plastic blade type.
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
Access the breakers and fuses as follows:
1. Stop engine and remove key.
2. Move right (cab-forward) side platform rearward, refer
to 5.5.1 Opening Platforms (Standard Position), page
291 .
3. Remove wing nut (A) and remove fuse box cover (B).
4. Refer to the decal on inside of cover for identification
of fuses and circuit breakers.
5. A cover may be installed over the circuit breaker.
Remove it to access the breaker.
Figure 5.190: Fuse Box
169887 378 Revision A