Setting the hydraulic overload pressure – MacDon M205 Operators Manual User Manual

Page 115

1. Turn ignition key to RUN, or start the engine. Refer to

2. Press PROGRAM (A) and SELECT (C) on cab display

module (CDM) to enter Programming Mode.

• WINDROWER SETUP? is displayed on the

upper line.

• NO/YES is displayed on the lower line.

3. Press right (B) arrow to select YES. Press SELECT (C).

• SET KNIFE SPEED? is displayed.

• The current knife speed is displayed on the

lower line.

Figure 3.99: CDM Programming Buttons

4. Press left (B) or right (C) arrows to select knife speed.

Press SELECT (D).

5. Press PROGRAM (A) to exit Programming Mode or

press SELECT (D) to proceed to next WINDROWER
SETUP action.

Figure 3.100: Selecting Knife Speed

Setting the Hydraulic Overload Pressure

NOTE:

• This procedure requires installation of the optional Pressure Sensor (MD #B5574). For overload pressure values,

refer to Pressure Sensor installation instructions (MD #169031).

• To enable sensor, refer to

169887

Revision A