MacDon M205 Operators Manual - Manual (Page 145)

OPERATOR’S STATION
5. Press SELECT (D) until ACTIVATE FUNCTIONS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
6. Press right (C) arrow to select YES. Press
SELECT (D).
Figure 3.169: Selecting Activate Functions
CAUTION
Check to be sure all bystanders have cleared the area.
7. Press SELECT (D) until ACTIVATE REEL HT is
displayed on the upper line.
• DOWN/UP is displayed on the lower line.
8. Press and hold left (B) arrow to lower reel. Press and
hold right (C) arrow to raise reel.
Verify reel is functioning properly.
9. Press PROGRAM (A) to exit Programming
Mode or press SELECT (D) to proceed to next
ACTIVATE FUNCTION.
Figure 3.170: Changing Reel Height
Testing the Header Tilt Function using the Cab Display Module (CDM)
NOTE:
• Header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header .For more information, refer to 4.5 Attaching and
Detaching Headers, page 202 .
• Engine MUST be running to perform this procedure.
169887 129 Revision A