MacDon M205 Operators Manual User Manual
Page 100
Display (A)
Flashing
Alarm Tone
Description
NO OPERATOR / NOT IN
PARK
ENGINE SHUTDOWN
Continuous tone
Operator not detected in seat
with header engaged or out of
N-DETENT with machine moving
at <5mph (8 km/h): engine
shutdown after 5 seconds
NO OPERATOR
Continuous tone
Engine shutdown when Operator
not detected in seat with machine
moving >5 mph (8 km/h)
NOT IN PARK
X
Short beep with each flash
GSL or interlock switches not
closed with key ON / engine OFF
PLACE GSL INTO “N”
Beeps at 2 per second until
corrected
GSL or interlock switches not
closed with key ON / engine OFF
SLOW DOWN
X
Short beep with each flash
Ground speed is greater than
or equal to 25 mph (40 km/h):
Operator should pull back on the
GSL to reduce ground speed
TRANS OIL PRESS
X
Continuous loud tone until oil
pressure is regained
Low transmission charge oil
pressure
TRANS OIL TEMP
X
Ongoing intermittent moderate
tone until temperature is below
acceptable level
Transmission oil temperature
above 221°F (105°C)
##.# LOW VOLTS
X
Single loud tone for 10 seconds Voltage below 11.5
##.# HIGH VOLTS
X
Single loud tone for 10 seconds Voltage above 15.5
169887
84
Revision A