Air conditioning compressor coolant cycling, 4daily checks and maintenance, Daily checks and maintenance – MacDon M205 Operators Manual User Manual

Page 167: 4 daily checks and maintenance

d. Adjust tension on air conditioning (A/C) compressor belt. Refer to

e. Distribute A/C refrigerant by cycling A/C switch. Refer to

Check the entire A/C system for leakage at the beginning of each season.

2. Perform annual maintenance. Refer to

Air Conditioning Compressor Coolant Cycling

IMPORTANT:
Perform the following steps whenever the machine is first started after storage for more than one week:

1. Turn blower switch (A) to the first position, turn

temperature control switch (D) to maximum heating,
and A/C control switch (B) to OFF.

2. Start engine, and operate at low idle until engine

is warm.

3. Click A/C switch (B) from OFF to ON for one second,

then back to OFF for 5 to 10 seconds. Repeat this step
ten times.

Figure 4.6: Climate Control

A - Blower Switch

B - Air Conditioning Switch

C - Outside Air Switch

D - Temperature Control

4.3.4

Daily Checks and Maintenance

Perform the following checks and recommended maintenance before operating the windrower every day:

1. Check the machine for leaks.

NOTE:
Use proper procedure when searching for pressurized fluid leaks. Refer to

2. Check for missing or broken parts.

3. Clean the windows and mirrors to ensure good visibility in all directions. Stand on the platform to access the

rear window. Hold onto the handholds on the cab front corners and stand on the header anti-slip strips to wash
the front window.

4. Clean all lights and reflective surfaces to maintain visibility to others.

5. Perform daily maintenance. Refer to

169887

151

Revision A