Headlights: engine-forward, Aligning headlights, Danger – MacDon M205 Operators Manual User Manual
Page 374
1. Stop the engine and remove the key.
2. Open the right cab-forward platform to expose the
batteries. Refer to
5.5.1 Opening Platforms (Standard
3. The battery main disconnect switch (A) is located on
the right-hand frame rail beside the batteries. Ensure
battery switch (A) is switched to POWER OFF position.
4. Remove cable ties securing battery cables to
battery clamp.
IMPORTANT:
BATTERY IS NEGATIVE GROUNDED. Always connect
red starter cable to the positive (+) terminal of battery
and black ground cable to negative (-) terminal of battery.
Reversed polarity in battery or alternator may result in
permanent damage to electrical system.
Figure 5.144: Battery Switch
5. Remove plastic caps from battery posts.
6. Attach positive (red) cable terminals to positive post (A)
on batteries and tighten. Reposition plastic covers
onto clamps.
7. Attach negative (black) cable terminals to negative
post (B) on batteries and tighten clamps.
8. Turn battery switch to POWER ON position.
9. Close the platform, refer to
Figure 5.145: Batteries
Headlights: Engine-Forward
Aligning Headlights
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
NOTE:
Header should be attached and raised to maintain proper windrower stance.
169887
358
Revision A