Avaya P580 - Manual (Page 631)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 19-19
Analyzing Network Performance By Using RMON and Ethernet Statistics
CLI Command
Use the following CLI commands to configure Fabric mode 2 port
mirroring. You must be in Global Configuration command mode to
enter these commands.
* Note: For information on how to enter Global Configuration
command mode, see “Accessing/Exiting the Command
Modes” in Chapter 1 of Command Reference Guide for the
Avaya P550R, P580, P880, and P882 Multiservice Switches,
v5.3.1.
To set up port mirroring, use the following CLI command:
# set port mirror Fabric_mode2 source-port port-range> mirror-port channel
direction {tx | rx | both | sa | da} sampling {always | disable |
periodic} [sa ] [da ] [max-packets-
sec ]
For more information about this command see “set port mirror
Fabric_mode2” in Chapter 19, “Port,” of the Command Reference
Guide for the Avaya P550R, P580, P880, and P882 Multiservice
Switches, v5.3.1.
Removing a Fabric Mode 2 Port Mirror
Web Agent
Procedure
To remove a port mirror on a switch in Fabric mode 2 by using the
Web Agent:
1. Expand the Modules & Ports folder.
2. Click Port Mirroring.
The Port Mirroring Information page opens.
3. In the Source Port column, select None for the port mirror that
you want to remove.
4. Click Apply.