Using the cli – Avaya P580 User Manual
Page 619
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
19-7
Analyzing Network Performance By Using RMON and Ethernet Statistics
Using the CLI
To view network statistics using the CLI, enter the following
command in Privileged mode:
num|mod-swport-spec> Refer to the Command Reference Guide for the Avaya P550R, P580, P880, Jabbers Jabbers indicate that devices on Possible causes: • Bad network interface card • Repeater network with looped traffic Possible actions (respectively): • Replace the network interface card. • Rewire network to remove the loop. Collisions Counts number of times that • 10 percent: Normal collision rate for shared • 30 percent: Collisions begin to interfere with • 70 percent: Practical limit for network to remain A full-duplex link should not Possible causes: • Busy network • Broken adapter (not listening before • Network loop Possible actions (respectively): • If you have multiple stations on a switch segment, • Isolate each adapter to see if the problem ceases. • Activate spanning tree to resolve loops automatically. • Ensure that there are no connections to the same Table 6-120. Ethernet Interface Statistics Web Page Fields Statistic Indicates Actions 4 of 4
and P882 Multiservice Switches, v5.3.1 for details about this command.
the networks are sending
improper electrical signals.
Because Ethernet uses electrical
signalling to determine whether
or not it is okay to transmit, a
jabber condition can halt all
traffic on a segment.
(half-duplex
links only)
packets have collided on the
network. Collisions increase as
network use of shared segments
increases. Therefore, if the
collision rate increases without
an increase of network use, it
might indicate a problem.
Guidelines for appropriate
collision rates are:
Ethernet segment.
performance.
functioning.
show collision activity. Collisions
are rare in a switched network,
unless your switched segments
attach to multiple ends stations
(a legal configuration option).
broadcasting)
reconfigure network into
segments with fewer
stations.
station where both
connections are
simultaneously active.