Avaya P580 - Manual (Page 564)

16-22 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
Enabling IGMP Snooping
You can enable IGMP snooping using either the Web Agent or the
CLI.
Using the Web
Agent
To enable IGMP Snooping using the Web Agent:
1. Select IGMP Snooping from the L2 > Intelligent Multicast
group on the Web Agent window. The IGMP Snooping
dialog box opens (Figure 16-11).
* Note: IGMP snooping only works on VLANS that have an
IGMP interface enabled. You must also enable intelligent
multicasting on a global basis.
2. Select Enable from the State field.
3. Click APPLY to complete the operation or CANCEL to
ignore the operation.
Using the CLI
To enable IGMP Snooping using the CLI, enter the following
command from Configure mode:
(configure)# set igmp-snooping enable
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3.1 for details about this command.
Viewing IGMP Snooping Statistics
You can view IGMP snooping statistics using either the Web Agent
or the CLI.
Using the Web
Agent
To view IGMP snooping using the Web Agent:
1. Select IGMP Snooping from the L2 > Intelligent
Multicast group on the Web Agent window. The IGMP
Snooping dialog box opens (Figure 16-11).
2. Refer to Table 6-102 for an explanation of the IGMP
Snooping dialog box parameters:
3. Click:
— CLEAR to clear the statistics.
— REFRESH to refresh the contents of the table.