Avaya P580 - Manual (Page 276)

7-18 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
4. Synchronize the Active and Standby supervisors (CPUs).
(Refer to Table 6-12 for more information on the CPU
Redundancy Configuration dialog box parameters).
5. Click SYNCHRONIZE to start the synchronization process.
6. Reset the standby supervisor from the CLI to initialize the
changes.
* Note: If the 48-port mode is different on the Active and
Standby Supervisor modules, the standby Supervisor
module will automatically reset.
Using the CLI
To synchronize the Active and redundant CPU’s using the CLI. enter
the following command in Enable mode:
># cpu_redundancy sychronize
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3.1 for more details about this
command.
Table 6-12. CPU Redundancy Status Dialog Box Parameters
Parameter Definition
Status Displays the functional status of the CPU modules.
Power-Up/
Reset Image Displays the image the CPU will use upon reset.
APP1 • Version - Displays the version of the image in
application 1 (APP1) for each supervisor module.
Checksum - Displays the checksum for the
image running in APP1.
APP2 • Version - Displays the version of the image in
application 2 (APP2) for each supervisor module.
Checksum - Displays the checksum for the
image in APP2.
Startup Config • Date/Time Modified - Displays the date and
time that the configuration (startup.txt) was
modified.
• Checksum - Displays the checksum for the
image in the Startup Config.