Modifying igmp interfaces using the web agent – Avaya P580 User Manual
Page 341
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
9-55
Configuring IP Routing
Modifying IGMP
Interfaces Using
the Web Agent
To modify IGMP interfaces from the Web Agent:
1. Select Interfaces from the Routing > IGMP group on the
Web Agent window. The IGMP Interfaces dialog box opens
(Figure 9-18)
* Note: You must first enable “multicast protocol”on an
interface before you can configure IGMP. Refer
to “Displaying Existing IP Interfaces” earlier in this
chapter for more information on how to select a
multicast protocol.
Figure 6-42. IGMP Interfaces Dialog Box
2. Refer to Table 6-21 to modify an IGMP interface:
Table 6-21. IGMP Interface Parameters
Parameter
Allows you to...
Select
Select the interface to be modified.
Interface
Displays the IP interface that is configured with IGMP.
IP Address
Displays the IP address associated with this interface.
Note:
This parameter is not configurable from the
IGMP configuration dialog box.
IP Address Mask
Displays the subnet mask associated with this interface.
Note:
This parameter is not configurable from the
IGMP configuration dialog box.