Avaya P580 - Manual (Page 468)

12-12 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
* Note: It is also possible to create a static route by,
making a RIP source route from the IPX Static
Route Table.
Figure 6-99. IPX Static Routes Dialog Box
CLI Command
To create IPX static routes using the CLI, enter the following
command in Interface mode:
(config-if:)#: ipx route
address|range>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3 for details about this
command.
Deleting IPX Static Routes
You can delete an IPX static route using either the Web Agent or the
CLI.
Web Agent
Procedure
To delete an IPX static route using the Web Agent:
1. Select Static Routes from the Routing > IPX >
Configuration group on the Web Agent window. The IPX
Static Routes dialog box opens (see Figure 12-8).
2. Select the checkbox for the IPX static route that you want to
delete from the Select column.
3. Click DELETE to remove the IPX static route, or CANCEL to
restore the IPX static route.