Creating ipx static routes, Creating ipx static routes -9, Cli command – Avaya P580 User Manual
Page 465
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
12-9
Configuring IPX Routing
CLI Command
To begin the creation of a new IPX interface using the CLI, enter the
following command in Configure mode:
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3 for details about this
command.
Creating IPX Static Routes
You can create IPX static routes using either the Web Agent or the
CLI.
SAP
Select Disable to prevent IPX SAP from routing globally.
This affects all IPX interfaces set up to use the IPX SAP
routing protocol. The default value is Enable.
Type 20 Packet
Propagation
Specify whether or not Type 20 packets can be sent,
received, disabled, or sent and received on a given
interface.
Options include:
Disable - Type 20 packets are neither sent nor received.
Inbound - Type 20 packets are received.
Outbound - Type 20 packets are sent.
Both - Type 20 packets are sent and received.
The default value is Disable
Parameter
Allows you to...