Avaya P580 User Manual
Page 429
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
11-11
Configuring the OSPF Routing Protocol
e. Click Apply.
Table 6-55. OSPF Interface Dialog Box Parameters
Parameter
Definition
Select
Select the OSPF interface to be modified.
Interface
Displays IP interface (VLAN) that has OSPF enabled.
Note:
This is a read-only field.
IP Address
Displays IP address associated with the OSPF interface.
Note:
This is a read-only field.
Area
Enter the area ID configured for this interface. The default is
0.0.0.0.
DR Priority
Enter the decimal value for this interface for DR priority
functionality. The value range is 0-255. The default is 1.
Transmit Delay
Enter the estimated time (seconds) it takes to transmit a link state
update packet over this interface.The value range is 1-3600. The
default is 1.
Retransmit
Interval
Enter the time (seconds) between link-state advertisement
retransmissions, for adjacencies belonging to this interface. This
value is also used when retransmitting database description and
link-state request packets. The value range is 1-3600. The default is
5.
Hello Interval
Enter the time (seconds) between the Hello packets that the router
sends on the interface. This value must be the same for all routers
attached to a common network. The value range is
1-65535. The default is 10.
Dead Interval
Enter the time (seconds) that a router's Hello packets have not been
seen before it's neighbors declare the router down. This should be
some multiple of the Hello interval. This value must be the same for
all routers attached to a common network. The value range is 1-
65535. The default is 40.
Poll Interval
Enter the larger time interval (seconds) between the Hello packets
sent to an inactive non-broadcast multiaccess neighbor. he value
range is 1-65535. The default is 120.
Cost
Enter the cost metric associated with this interface. The value range
is 1-65535. The default is 1.
Authentication
Select the type of authentication available for use on a given OSPF
interface. Authentication types are:
• None (default)
• Simple Password
• MD5 Authentication
Key
Enter the authorization key value for the interface.