Enabling iedr, Enabling iedr for hunt groups – Avaya P580 User Manual
Page 225
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
5-45
Configuring Port Parameters
Enabling IEDR
* Note: To enable IEDR for ports in a hunt group, you must use
a different command that enables the feature globally for
all ports in all hunt groups on the switch. For
information on this command, see
* Note:
(SPR 5938)
Do not use ISL Tagging (Trunk Mode:
Multilayer) on ports that have IEDR enabled.
IEDR is disabled by default on gigabit ports. To enable the feature:
1. Enter Global Configuration mode.
The CLI displays the
prompt.
* Note: For information on how to enter this mode, see
“Accessing/Exiting the Command Modes” in
Chapter 1, “Overview,” of Cajun P550R/P880/
P882 Command Line Interface Reference Guide.
2. Enter the following command:
set port internal-error-shutdown {
To disable IEDR, enter:
set port internal-error-shutdown {
all-ports} disable
Enabling IEDR for Hunt Groups
This procedure globally enables IEDR for all ports in all hunt groups
on the switch.
* Note:
(SPR 5909)
All ports that are enabled for IEDR will be
subjected to the hunt group IEDR setting if they are
placed in a hunt group whether they are
administratively disabled or enabled. Ports that are
enabled for IEDR before being placed in a hunt group
will still display when showing configuration but they
still will be subjected to take on the hunt group setting
until they are removed from the hunt group.
To globally enable IEDR for all ports in hunt groups: