Avaya P580 - Manual (Page 204)

5-24 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter 5
4. Refer to "Configuring Physical Port Parameters on Gigabit
Ports" and "Configuring Physical Port Parameters on Fast
Ethernet Ports" earlier in this chapter to configure the port
parameters.
5. Click APPLY to save your changes, or Restore to restore
previous settings.
Configuring Switch Port Parameters
This section contains the following procedures:
■
Configuring Switch Port Parameters
■
Configuring Fast Start Mode
■
Using the All Module Ports Configuration Window
■
Viewing Switch Port Parameters
Configuring Switch Port Parameters
You can configure how each switch port performs its switching
functions (for example, VLAN parameters, hunt group assignments,
trunk mode, and frame tag scheme) through the switch port
parameters.
You can configure switch port parameters using either the Web
Agent or the CLI.
CAUTION
Before changing the VLAN that a port is assigned to, you must
remove the port from the hunt group that the port is assigned to. Do
not attempt to change the VLAN and remove the port from the hunt
group simultaneously. If you attempt to change the VLAN that the
port is assigned to and remove the port from the hunt group
simultaneously, the switch assigns all ports in the hunt group to the
new VLAN.
Web Agent
Procedure
To configure switch port parameters using the Web Agent:
1. Select Configuration from the Modules & Ports group on
the Web Agent window. The Module Information dialog
box opens (Figure 5-1).