Avaya P580 - Manual (Page 299)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 9-13
Configuring IP Routing
Refer to Table 6-15 to configure the IP Global Configuration
dialog box.
Table 6-15. IP Global Configuration Parameters
Parameter Allows you to...
IP Unicast
Forwarding Disable IP Unicast Forwarding. Must be enabled for Unicast
Forwarding. The default setting is Enable.
IP Multicast
Forwarding Enable IP multicast forwarding on a global basis. Must be
enabled for Multicast Routing or Forwarding. The default setting
is Disable.
IP Source Routing Disable IP source routing globally. The default setting is Enable.
VRRP Disable VRRP globally. The default setting is Enable.
BOOTP/DHCP
Relay Agent Enable Client requests for an IP address and forwards their
requests to a server. This agent also relays responses from the
server to the client. The default setting is Disable.
BOOTP/DHCP
Option 82-Circuit
Info Enable This sub-option 82 allows the sending of an agent-local
identifier of the circuit (slot/physical port number) for a BootP/
DHCP client-to-server DHCP request. The default setting is
Disabled.
BOOTP/DHCP
Option 82- Agent
Info Enable This sub-option 82 allows the Avaya Multiservice switch
to send its IP address and System name along with the BootP/
DHCP client-to-server request. The Default setting is Disabled
Limit Proxy ARP to
Same Network Enable Proxy ARP on the same network. When enabled, the
router responds to ARP requests when the source and target IP
address are in the same IP network and different IP subnets.
When disabled, the router responds to ARP requests when the
source and target IP address are in different networks.
The default setting is Disable.
Use Default Route
for Proxy ARPs Disable the use of the default route on your switch as the route
for Proxy ARPs. For example, if you have a default route
configured to reach the 0.0.0.0 IP address, then any ARP request
that does not match any of the other routes in your IP routing
table will automatically go to this default route. The default
setting is Enable.
Maximum Number
of Routes Enter the maximum number of routes that you want added to
the routing table. The default number of routes is 16384.
Note: These routes refer only to IP Unicast entries.
Maximum Number
of ARP Cache
Entries Enter the maximum number of ARP cache entries. ARP entries
refers to the space available for the IP address table. When you
increase the number of entries, it may cause the table to be
relearned more frequently. Consequently, it will make address
space usage more efficient. The default maximum number of
entries is 16384.