Avaya P580 - Manual (Page 346)

9-60 Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Chapter
Figure 6-44. DVMRP Interfaces Dialog Box
* Note: You must first set “multicast protocol” on an interface to
DVMRP before you can configure DVMRP. Refer to
“Displaying Existing IP Interfaces”, earlier in this chapter,
and enable a multicast protocol for this interface.
2. Refer to Table 6-23 to complete your DVMRP configuration:
Table 6-23. DVMRP Interface Parameters
Parameter Defines the...
Select Select a DVMRP interface that you want to configure.
Interface Displays the Interface that is configured with the
DVMRP multicast protocol.
IP Address Displays the IP address of each interface. You cannot
modify this field.
IP Address Mask Displays the Subnet mask for each interface. You
cannot modify this field.
Interface Type Select an Interface type. You can configure the
interface type as:
• Broadcast - All traffic is forwarded through the
routers. This is not a tunnel and does not require
encapsulation.
• Non-Encapsulated Tunnel - All multicast data
traffic is IPIP encapsulated, but the protocol
messages are unicast.
• IPIP Tunnel - All multicast traffic (data and
protocol messages) are encapsulated in IP unicast
packets with the protocol set to IPIP (IP in IP).
Tunnel Endpoint Address Displays the Tunnel endpoint IP address of a router.
You can modify this setting to represent the end router
IP address to which you want to send datagrams
through a tunnel. The origin and endpoint routers are
separated by a gateway(s) or a router(s) that do not
support DVMRP.
Interface Metric Displays the Cost metric for the interface.