Avaya P580 - Manual (Page 485)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 13-3
Configuring IPX RIP Protocol
3. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Configuring IPX
RIP Interfaces
Using the CLI
To configure IPX RIP interfaces using the CLI, enter the following
command in Interface mode:
(config-if: ):# ipx rip
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3 for details about this
command.
Creating and Modifying IPX RIP Filters
You can create and modify IPX RIP filters from either the Web Agent
or the CLI.
Creating and
Modifying IPX
RIP Filters Using
the Web Agent
To create and modify IPX RIP filters using the Web Agent:
1. Select Filters from the Routing > IPX > RIP group on the
Web Agent window. The IPX RIP Filters dialog box opens
(Figure 6-109). Only the CREATE button is displayed when
no filters are configured.
Figure 6-109. IPX RIP Filters Dialog Box
2. Select CREATE to create a new filter. The Add IPX RIP
Filter dialog box opens (Figure 6-110).