Avaya P580 - Manual (Page 345)

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 9-59
Configuring IP Routing
6. Click APPLY to save your changes, or CANCEL to restore
previous settings.
Configuring the
DVMRP Global
Configuration
Using the CLI
To configure DVMRP globally using the CLI:
# router dvmrp
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3.1 for details about this
command.
Modifying a DVMRP Interface
You can modify a DVMRP interface using either the Web Agent or
the CLI.
Modifying the
DVMRP
Interface Using
the Web Agent
To modify a DMVRP interface using the Web Agent:
1. Select Interfaces from the Routing > DVMRP group of the
Web Agent window. The DVMRP Interfaces dialog box
opens (see Figure 6-44).
Minimum Flash Update
Interval Enter the update interval (in seconds) between flash
updates. This represents the minimum time between
advertisements of the same route.
Maximum Number of
Routes Enter the maximum number of routes for this
interface.
Route Report Interval Enter the report interval (in seconds) that elapses
between delivery of DVMRP routing table updates.
Route Replace Time Enter the amount of replace time (in seconds) before
which a route entry will be removed if it is not
refreshed.
Route Hold Down Time Set the hold down time (in seconds) that the switch
reports unavailable routes with a metric of infinity.
Prune Message Lifetime Enter the lifetime (in seconds) that a transmitted
upstream prune message persists.
Prune Message Retransmit
Interval Enter the retransmit interval (in seconds) between
the transmittal of generated upstream prune messages
on your network.
Graft Message Retransmit
Interval Enter the retransmit interval (in seconds) between
the transmittal of generated upstream graft messages.
Table 6-22. DVMRP Global Configuration Dialog Box Parameters continued
Parameter Allows you to...