Initialize and setup, Overview, Chapter 2 — initialize and setup -1 – Avaya P580 User Manual
Page 59: Overview -1
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
2-1
2
Initialize and Setup
Overview
The following information and procedures that are provided in this
chapter are common to both layer 2 and layer 3 module
configuration:
■
Setting Up Your Laptop or PC Monitor
■
Configuring the Supervisor Module Using the CLI
■
Configuring the Switch Using the Web Agent
■
Configuring Custom Access Types
■
■
Remote Authentication Dial-In User Service (RADIUS) Client
Support
■
Changing the Console Serial Port Settings
■
Configuring Dial-Up Networking
■
Changing the TCP Ports for HTTP and Telnet
■
* Note: The last step in each procedure tells you to click Apply to
save any setup or changes you made. This saves the
setup or any changes to the Running config only. The
Startup config has not changed. Therefore, these and
other changes will be lost if your switch goes down or if
you power it off.
To save these changes to the Startup Config, you must
copy the Running config to the Startup config. Refer
to the "Copying Configuration Files" section later in this
chapter.