Configuring the routing information protocol (rip), Overview, Configuring rip on the switch – Avaya P580 User Manual

Page 405: Overview -1, Configuring rip on the switch -1

background image

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide,v5.3.1

10-1

10

Configuring the Routing
Information Protocol (RIP)

Overview

* Note: To globally enable RIP, refer to Chapter 9, "Configuring

The information and procedures provided in this chapter pertain to
50 series layer 3, and Licensed 80 series module configurations only:

This section describes:

■

Configuring RIP on the Switch

■

Modifying RIP Interfaces

■

Creating Trusted RIP Neighbors

■

Viewing RIP Statistics

■

■

NBMA IP Interfaces

Configuring RIP on the Switch

You can configure the RIP from either the Web Agent or the CLI.

* Note: MD5 authentication in the 5.X versions of switch

software is not compatible with MD5 authentication in
earlier versions of the software.

If you enable MD5 authentication on a switch that is
running 5.X software and on a switch that is running
4.X software, the switches do not exchange routing
information.

This manual is related to the following products:

P550R