Using the cli – Avaya P580 User Manual
Page 295
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
9-9
Configuring IP Routing
Using the CLI
Using the CLI to create an IP interface requires two CLI commands.
1. Enter Configure mode.
2. Create an Interface Name first.
Example: Interface myif type ethernet
3. Assign an IP address to the interface.
Example: (config-if:myif)# ip address 192.168.97.1 255.255.255.0
RIP
Enable or disable RIP. The default value is Disable.
OSPF
Enable or disable OSPF. The default value is
Disable.
Note:
To Enable OSPF, The Admin State of the IP
interface must be set to down. Enable OSPF
and then set the Admin State to up.
Multicast
Protocol
Specify the multicast protocol for the interface.
Options include:
• None (Default)
• DVMRP
• IGMP
* Note: By Default, multicast forwarding is
disabled. To enable multicast
forwarding go to the IP Global
Configuration page.
Proxy ARP
Enable or disable Proxy ARP. The default value is
Disable.
ICMP Redirect
Enable or disable ICMP Redirect (IDRP). The default
value is Enable.
NetBIOS UDP
Rebroadcast
Enable or disable NetBIOS UDP Rebroadcasts. The
default value is Disable.
VRRP
Enable or disable Virtual Redundancy Router
Protocol. The default value is Disable.
BOOTP/DHCP
Relay Gateway
Enable or disable the BOOTP/DHCP Relay Agent.
The default value is Enable.
Table 6-14. Add IP Interface Web Page Fields continued
Parameter
Allows you to...