Configuring spanning tree protocol ports, Configuring spanning tree protocol ports -20, Using the cli – Avaya P580 User Manual
Page 150: Using the web agent
4-20
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1
Chapter 4
Using the CLI
To manage spanning trees using the CLI, enter the following
command from Configure mode:
(configure)# set spantree
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, Version 5.3 for details about this
command.
Configuring Spanning Tree Protocol Ports
You can configure the bridge ports for Spanning Tree using either
the Web Agent or the CLI.
Using the Web
Agent
To configure spanning tree bridge ports using the Web Agent:
1. Select Spanning Tree from the L2 Switching folder on the
Web Agent window. The Spanning Tree Information
window opens (Figure 4-9).
2. Select the port number listed in the Bridge Ports column.
The Spanning Tree Per Module Bridge Port
Information window opens (Figure 4-11).
Figure 4-9. Spanning Tree Per Module Bridge Port Dialog Box