Allied Telesis AT-S95 CLI - Manual (Page 97)

Ethernet Configuration Commands
Page 85
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The no speed command in a port-channel context returns each port in the port-channel to its maximum capability.
Example
The following example configures the speed operation of Ethernet port 1/g5 to 100 Mbps operation.
This document uses the following conventions to highlight important information:
Note
The speed setting for SFP ports is dependent on the maximum speed of the port.
duplex
The duplex Interface Configuration (Ethernet) mode command configures the full/half duplex operation of a given
Ethernet interface when not using auto-negotiation. Use the no form of this command to restore the default
configuration.
Syntax
duplex {half | full}
no duplex
Parameters
•
half — Forces half-duplex operation
• full — Forces full-duplex operation
Default Configuration
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
When configuring a particular duplex mode on the port operating at 10/100 Mbps, disable the auto-negotiation on
that port.
Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps.
Console(config)# interface ethernet 1/g5
Console(config-if)# speed 100