Allied Telesis AT-S95 CLI - Manual (Page 38)

Page 26
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Command Mode
Global Configuration mode
User Guidelines
•
The default and optional list names created with the aaa authentication enable command are used with the
enable authentication command.
• The additional methods of authentication are used only if the previous method returns an error, not if it fails.
To ensure that the authentication succeeds even if all methods return an error, specify none as the final
method in the command line.
• All aaa authentication enable default requests sent by the device to a RADIUS or TACACS+ server include
the username $enabx$., where x is the requested privilege level.
Example
The following example sets the enable password for authentication when accessing higher privilege levels.
login authentication
The login authentication Line Configuration mode command specifies the login authentication method list for a
remote telnet or console. Use the no form of this command to return to the default configuration specified by the
aaa authentication login command.
Syntax
login authentication {default | list-name}
no login authentication
Parameters
•
default — Uses the default list created with the aaa authentication login command.
• list-name — Uses the indicated list created with the aaa authentication login command.
Default Configuration
Uses the default set with the command aaa authentication login.
Command Mode
Line Configuration mode
User Guidelines
Changing login authentication from default to another value may disconnect the telnet session.
Example
The following example specifies the default authentication method for a console.
Console(config)# aaa authentication enable default enable
Console(config)# line console
Console(config-line)# login authentication default