Allied Telesis AT-S95 CLI - Manual (Page 300)

Page 288
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Example
This example configures ethernet port 1/g8 as a protected port, so that all traffic is sent to its uplink (ethernet port
1/g9).
switchport mode
The switchport mode Interface Configuration mode command configures the VLAN membership mode of a port.
Use the no form of this command to return to the default configuration.
Syntax
switchport mode {access | trunk | general}
no switchport mode
Parameters
•
access — Indicates an untagged layer 2 VLAN port.
• trunk — Indicates a trunking layer 2 VLAN port.
• general — Indicates a full 802-1q supported VLAN port.
Default Configuration
All ports are in access mode, and belong to the default VLAN (whose VID=1).
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines.
Example
The following example configures Ethernet port 1/g16 as an untagged layer 2 VLAN port.
Console(config)# interface ethernet 1/g8
Console(config-if)# switchport forbidden vlan add 234-256
Console(config-if)# exit
Console(config)# interface ethernet 1/g9
Console(config-if)# switchport protected ethernet 1/g1
Console(config)# interface ethernet 1/g16
Console(config-if)# switchport mode access