Allied Telesis AT-S95 CLI - Manual (Page 328)

Page 316
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the number of seconds between re-authentication attempts, to 300.
dot1x re-authenticate
The dot1x re-authenticate Privileged EXEC mode command manually initiates a re-authentication of all 802.1X-
enabled ports or the specified 802.1X-enabled port.
Syntax
dot1x re-authenticate [ethernet interface]
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example manually initiates a re-authentication of 802.1X-enabled Ethernet port 1/g16.
dot1x timeout quiet-period
The dot1x timeout quiet-period Interface Configuration mode command sets the number of seconds that the
device remains in the quiet state following a failed authentication exchange (for example, the client provided an
invalid password). Use the no form of this command to return to the default configuration.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
Console(config)# interface ethernet 1/g16
Console(config-if)# dot1x timeout re-authperiod 300
Console# dot1x re-authenticate ethernet 1/g16