Allied Telesis AT-S95 CLI - Manual (Page 341)

802.1x Commands
Page 329
Parameters
•
mac-only — Enable authentication based on the station's MAC address only. 802.1X frames are ignored.
• mac-and-802.1x — Enable 802.1X authentication and MAC address authentication on the interface.
Default Configuration
Disabled.
Command Mode
Interface configuration (Ethernet)
User Guidelines
Guest VLAN must be enabled when MAC authentication is enabled.
Static MAC addresses can't be authorized. Do not change authenticated MAC address to static address.
It is not recommended to delete authenticated MAC addresses.
Reauthentication must be enabled when working in this mode.
Example
The following example enables authentication based on the station's MAC address.
show dot1x advanced
The show dot1x advanced privileged EXEC mode command displays 802.1X advanced features for the switch
or for the specified interface.
Syntax
show dot1x advanced
Parameters
•
interface — Ethernet interface.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC
User Guidelines
There are no user guidelines for this command.
Example
Console# configure
Console(config)# interface ethernet 1/g1
Console(config-if)# dot1x mac-authentication