Allied Telesis AT-S95 CLI - Manual (Page 113)

Ethernet Configuration Commands
Page 101
The following example enables Broadcast storm control on port 1/g5 for aGE devices.
The following example enables Broadcast storm control on port 1/g5 .
port storm-control broadcast rate
The port storm-control broadcast rate Interface Configuration (Ethernet) mode command configures the
maximum Broadcast rate. Use the no form of this command to return to the default configuration.
Syntax
port storm-control broadcast rate rate
no port storm-control broadcast rate
Parameters
•
rate — Maximum kilobits per second of Broadcast and Multicast traffic on a port. Possible values are in a
range of 3500-1000000.
For FE ports, possible values are 70K - 100M.
For GE ports, possible values are in a range of 3500-1000000.
Default Configuration
For FE ports, the default storm control Broadcast rate is 3500Kbits/Sec.
For GE ports, the default storm control Broadcast rate is 12,000 Kbits/Sec.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast enable Interface Configuration mode command to enable Broadcast
storm control.
For FE ports, the software displays the actual rate since granularity depends on the requested rate.
For GE ports, the rate is rounded off to the nearest 64 Kbits/Sec (except for 1-63 Kbits/Sec which is rounded off to
64 Kbits/Sec). If the rate is 0, Broadcast packets are not forwarded.
Console(config)# interface ethernet 1/g5
Console(config)# port storm-control broadcast enable
Console(config)# interface ethernet 1/g5
Console(config)# port storm-control broadcast enable