Allied Telesis AT-S95 CLI - Manual (Page 279)

System Management Commands
Page 267
Example
The following example reloads Unit 2 of the stack.
stack change unit-id
Note
This command is operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE devices.
The stack change unit-id Global Configuration mode command is used to change the Unit ID of a specific unit.
Syntax
stack change unit-id unit-number to new-unit-number
Parameters
•
unit-number— Specifies the current number of the unit. (Range: 1-6)
• new-unit-number— Specifies the new number of the unit. (Range: 1-6)
Default Configuration
The automatically configured unit number is assigned.
Command Modes
Global Configuration mode
User Guidelines
This command is not relevant to standalone devices.
The command takes effect only after resetting the device.
Example
This example changes Unit Number 6 to Unit Number 5. The command takes effect only after resetting the device.
show stack
Note
This command is operational in the AT-S94/24, AT-S94/24POE, AT-S94/48 and AT-S94/48POE devices.
The show stack User EXEC mode command displays information about the status of a stack.
Console(config)# stack reload unit 2
Console# config
Console(config)# stack change unit-id 6 to 5