Allied Telesis AT-S95 CLI - Manual (Page 112)

Page 100
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
This command is relevant to FE devices only.
To control Multicasts storms, use the port storm-control broadcast enable and port storm-control broadcast
rate commands.
Example
The following example enables counting Broadcast and Multicast packets on Ethernet port 2/g3.
port storm-control broadcast enable
The port storm-control broadcast enable Interface Configuration (Ethernet) mode command enables Broadcast
storm control. Use the no form of this command to disable Broadcast storm control.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode command, to set the
maximum allowable Broadcast rate.
Use the port storm-control include-multicast Global Configuration mode command to enable counting
Multicast packets in the storm control calculation.
For FE devices, use the port storm-control include-multicast Interface Configuration (Ethernet) mode
command to enable counting Multicast packets and optionally unknown Unicast packets in the storm control
calculation.
For GE devices, use the port storm-control include-multicast Global Configuration mode command to enable
counting Multicast packets in the storm control calculation.
Example s
The following example enables Broadcast storm control on Ethernet port 1/g5 of a FE device.
Console(config)# interface ethernet 2/g3
Console(config-if)# port storm-control include-multicast
Console(config)# interface ethernet 1/g5
Console(config-if)# port storm-control broadcast enable