Allied Telesis AT-S95 CLI - Manual (Page 110)

Page 98
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
The following table describes the fields shown in the display:
Transmitted Pause Frames: 0
Console#
Console# show interfaces counters ethernet 1/g1
Port InOctets InUcastPkts InMcastPkts InBcastPkts
------ ----------- -------------- ----------- -----------
1/g1 183892 0 0 0
Port OutOctets OutUcastPkts OutMcastPkts OutBcastPkts
------ ----------- -------------- ------------ ------------
1/g1 9188 0 0 0
FCS Errors: 8
Single Collision Frames: 0
Late Collisions: 0
Oversize Packets: 0
Internal MAC Rx Errors: 0
Symbol Errors: 0
Received Pause Frames: 0
Transmitted Pause Frames: 0
Field Description
InOctets Counted received octets.
InUcastPkts Counted received Unicast packets.
InMcastPkts Counted received Multicast packets.
InBcastPkts Counted received Broadcast packets.
OutOctets Counted transmitted octets.
OutUcastPkts Counted transmitted Unicast packets.
OutMcastPkts Counted transmitted Multicast packets.
OutBcastPkts Counted transmitted Broadcast packets.
FCS Errors Counted received frames that are an integral number of octets in length but do
not pass the FCS check.
Single Collision Frames Counted frames that are involved in a single collision, and are subsequently
transmitted successfully.
Late Collisions Number of times that a collision is detected later than one slotTime into the
transmission of a packet.