Allied Telesis AT-S95 CLI - Manual (Page 102)

Page 90
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Example
In the following example, the counters for interface 1/g1 are cleared.
set interface active
The set interface active Privileged EXEC mode command reactivates an interface that was shutdown.
Syntax
set interface active {ethernet interface | port-channel port-channel-number}
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
• port-channel-number — Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command is used to activate interfaces that were configured to be active, but were shutdown by the system
for some reason (e.g., port security).
Example
The following example reactivates interface 1/g5.
show interfaces advertise
The show interfaces advertise Privileged EXEC mode command displays autonegotiation data.
Syntax
show interfaces advertise [ethernet interface | port-channel port-channel-number ]
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
• port-channel-number — Valid port-channel number.
Default Configuration
This command has no default configuration.
Console> clear counters ethernet 1/g1
Console# set interface active ethernet 1/g5