Allied Telesis AT-S95 CLI - Manual (Page 62)

Page 50
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
The following table describes the fields shown above.
show ports security addresses
The show ports security addresses Privileged EXEC mode command displays the current dynamic addresses
in locked ports.
Syntax
show ports security addresses [ethernet interface | port-channel port-channel-number]
Parameters
•
interface — A valid Ethernet port.
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Examples
In these examples, dynamic addresses in currently locked ports are displayed.
1/g2 Unlocked Dynamic - 28 - -
1/g3 Locked Disabled Discard,
Shutdown 8 Disable -
Field Description
Port Port number
Status Locked/Unlocked
Learning Learning mode
Action Action on violation
Maximum Maximum addresses that can be associated on this port in Static
Learning mode or in Dynamic Learning mode
Trap Indicates if traps are sent in case of a violation
Frequency Minimum time between consecutive traps
Console# show ports security addresses
Port Status Learning Current Maximum