Allied Telesis AT-S95 CLI - Manual (Page 54)

Page 42
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Default Configuration
No addresses are defined.
Command Mode
Interface Configuration (Ethernet, port-channel) mode. Cannot be configured for a range of interfaces (range
context).
User Guidelines
•
The command enables adding secure MAC addresses to a routed port in port security mode.
• The command is available when the port is a routed port and in port security mode.
• The address is deleted if the port exits the security mode or is not a routed port.
Example
In this example, the MAC-layer address 66:66:66:66:66:66 is added to port 1/g1.
show bridge address-table
The show bridge address-table Privileged EXEC mode command displays all entries in the bridge-forwarding
database.
Syntax
show bridge address-table [vlan vlan] [ethernet interface | port-channel port-channel-number]
Parameters
•
vlan — Specifies a valid VLAN, such as VLAN 1.
• interface — A valid Ethernet port.
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
•
Internal usage VLANs (VLANs that are automatically allocated on ports with a defined Layer 3 interface) are
presented in the VLAN column by a port number and not by a VLAN ID.
• "Special" MAC addresses that were not statically defined or dynamically learned are displayed in the MAC
Address Table.
Console(config)# interface ethernet 1/g1
Console(config-if)# port security routed secure-address 66:66:66:66:66:66