Allied Telesis AT-S95 CLI - Manual (Page 292)

Page 280
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
User Guidelines
There are no user guidelines for this command.
Example
The following example describes the help system .
terminal datadump
The terminal data-dump User EXEC mode command enables dumping all the output of a show command
without prompting. Use the no form of this command to disable dumping.
Syntax
terminal datadump
no terminal datadump
Default Configuration
Dumping is disabled.
Command Mode
User EXEC mode
User Guidelines
By default, a More prompt is displayed when the output contains more lines than can be displayed on the screen.
Pressing the Enter key displays the next line; pressing the Spacebar displays the next screen of output. The data-
dump command enables dumping all output immediately after entering the show command.
This command is relevant only for the current session.
Example
This example dumps all output immediately after entering a show command.
Console# help
Help may be requested at any point in a command by entering a question mark '?'. If nothing
matches the currently entered incomplete command, the help list is empty. This indicates
that for a query at this point, there is no command matching the current input. If the
request is within a command, enter backspace and erase the entered characters to a point
where the request results in a display.
Help is provided when:
1. There is a valid command and a help request is made for entering a parameter or argument
(e.g. 'show ?'). All possible parameters or arguments for the entered command are
displayed.
2. An abbreviated argument is entered and a help request is made for arguments matching the
input (e.g. 'show pr?').
Console> terminal datadump