Allied Telesis AT-S95 CLI - Manual (Page 81)

Configuration and Image File Commands
Page 69
boot system
The boot system Privileged EXEC mode command specifies the system image that the device loads at startup.
Syntax
boot system [unit unit] {image-1 | image-2}
Parameters
•
unit — Specifies the unit number.
• image-1 — Specifies image 1 as the system startup image.
• image-2 — Specifies image 2 as the system startup image.
Default Configuration
If the unit number is unspecified, the default setting is the master unit number.
Command Mode
Privileged EXEC mode
User Guidelines
Use the show bootvar command to find out which image is the active image.
Example
The following example loads system image 1 at device startup.
show running-config
The show running-config Privileged EXEC mode command displays the contents of the currently running
configuration file.
Syntax
show running-config
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Console# boot system image-1