Allied Telesis AT-S95 CLI - Manual (Page 327)

802.1x Commands
Page 315
Example
The following example enables 802.1X authentication on Ethernet port 1/g16.
dot1x re-authentication
The dot1x re-authentication Interface Configuration mode command enables periodic re-authentication of the
client. Use the no form of this command to return to the default configuration.
Syntax
dot1x re-authentication
no dot1x re-authentication
Default Configuration
Periodic re-authentication is disabled.
Command Mode
Interface Configuration (Ethernet)
User Guidelines
There are no user guidelines for this command.
Example
The following example enables periodic re-authentication of the client.
dot1x timeout re-authperiod
The dot1x timeout re-authperiod Interface Configuration mode command sets the number of seconds between
re-authentication attempts. Use the no form of this command to return to the default configuration.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
Parameters
•
seconds — Number of seconds between re-authentication attempts. (Range: 300 - 4294967295)
Default Configuration
Re-authentication period is 3600 seconds.
Console(config)# interface ethernet 1/g16
Console(config-if)# dot1x port-control auto
Console(config)# interface ethernet 1/g16
Console(config-if)# dot1x re-authentication