Allied Telesis AT-S95 CLI - Manual (Page 220)

Page 208
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Chapter 24.Spanning-Tree Commands
spanning-tree
The spanning-tree Global Configuration mode command enables spanning-tree functionality. Use the no form of
this command to disable spanning-tree functionality.
Syntax
spanning-tree
no spanning-tree
Default Configuration
Spanning-tree is enabled.
Command Modes
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables spanning-tree functionality.
spanning-tree mode
The spanning-tree mode Global Configuration mode command configures the spanning-tree protocol. Use the
no form of this command to return to the default configuration.
Syntax
spanning-tree mode {stp | rstp| mstp}
no spanning-tree mode
Parameters
•
stp — Indicates that the Spanning Tree Protocol (STP) is enabled.
• rstp — Indicates that the Rapid Spanning Tree Protocol (RSTP) is enabled.
• mstp — Indicates that the Multiple Spanning Tree Protocol (RSTP) is enabled.
Default Configuration
STP is enabled.
Console(config)# spanning-tree