Allied Telesis AT-S95 CLI - Manual (Page 105)

Ethernet Configuration Commands
Page 93
show interfaces status
The show interfaces status Privileged EXEC mode command displays the status of all configured interfaces.
Syntax
show interfaces status [ethernet interface| port-channel port-channel-number]
Parameters
•
interface — A valid Ethernet port. (Full syntax: unit/port)
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the status of all configured interfaces:
Console# show interfaces status
Port Type Duplex Speed Neg Flow
Ctrl Link
State Back
Pressure Mdix
Mode
---- ----------- ------ ----- ------- ---- ----- -------- ----
1/g1 1G-Copper -- -- -- -- Down -- --
1/g2 1G-Copper -- -- -- -- Down -- --
1/g3 1G-Copper -- -- -- -- Down -- --
1/g4 1G-Copper -- -- -- -- Down -- --
1/g5 1G-Copper Full 100 Enabled Off Up Disabled Auto
1/g6 1G-Copper -- -- -- -- Down -- --
1/g7 1G-Copper -- -- -- -- Down -- --
1/g8 1G-Copper -- -- -- -- Down -- --
1/g9 1G-Copper -- -- -- -- Down -- --
1/g10 1G-Copper -- -- -- -- Down -- --
1/g11 1G-Copper -- -- -- -- Down -- --
1/g12 1G-Copper -- -- -- -- Down -- --
1/g13 1G-Copper -- -- -- -- Down -- --
1/g14 1G-Copper -- -- -- -- Down -- --