Allied Telesis AT-S95 CLI - Manual (Page 186)

Page 174
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Parameters
•
retries — Specifies the retransmit value. (Range: 1 - 10)
Default Configuration
The software searches the list of RADIUS server hosts 3 times.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the number of times the software searches the list of RADIUS server hosts to 5
times.
radius-server source-ip
The radius-server source-ip Global Configuration mode command specifies the source IP address used for
communication with RADIUS servers. Use the no form of this command to return to the default configuration.
Syntax
radius-server source-ip source
no radius-source-ip source
Parameters
•
source — Specifies a valid source IP address.
Default Configuration
The source IP address is the IP address of the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
N/A
Example
The following example configures the source IP address used for communication with RADIUS servers to
10.1.1.1.
console(config)# radius-server retransmit 5
console(config)# radius-server source-ip 10.1.1.1