Allied Telesis AT-S95 CLI - Manual (Page 111)

Ethernet Configuration Commands
Page 99
show system flowcontrol
The show system flowcontrol Privileged EXEC mode command displays the flow control state on cascade
ports.
Syntax
show system flowcontrol
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
port storm-control include-multicast (IC)
The port storm-control include-multicast Interface Configuration (Ethernet) mode command counts Multicast
packets in Broadcast storm control. Use the no form of this command to disable counting Multicast packets.
Syntax
port storm-control include-multicast [unknown-unicast]
no port storm-control include-multicast
Parameters
•
unknown-unicast — Specifies also counting unknown Unicast packets.
Default Configuration
Multicast packets are not counted.
Oversize Packets Counted frames received that exceed the maximum permitted frame size.
Internal MAC Rx Errors Counted frames for which reception fails due to an internal MAC sublayer
receive error.
Received Pause Frames Counted MAC Control frames received with an opcode indicating the PAUSE
operation.
Transmitted Pause Frames Counted MAC Control frames transmitted on this interface with an opcode
indicating the PAUSE operation.
Console# show system flowcontrol