Allied Telesis AT-S95 CLI - Manual (Page 122)

Page 110
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Chapter 11.IGMP Snooping Commands
Note
In order to enable IGMP snooping, the user must enable bridge Multicast filtering
ip igmp snooping (Global)
The ip igmp snooping Global Configuration mode command enables Internet Group Management Protocol
(IGMP) snooping. Use the no form of this command to disable IGMP snooping.
Syntax
ip igmp snooping
no ip igmp snooping
Default Configuration
IGMP snooping is disabled.
Command Mode
Global Configuration mode
User Guidelines
IGMP snooping can only be enabled on static VLANs.
Example
The following example enables IGMP snooping.
ip igmp snooping (Interface)
The ip igmp snooping Interface Configuration (VLAN) mode command enables Internet Group Management
Protocol (IGMP) snooping on a specific VLAN. Use the no form of this command to disable IGMP snooping on a
VLAN interface.
Syntax
ip igmp snooping
no ip igmp snooping
Default Configuration
IGMP snooping is disabled .
Console(config)# ip igmp snooping