Allied Telesis AT-S95 CLI - Manual (Page 330)

Page 318
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
User Guidelines
The default value of this command should be changed only to adjust for unusual circumstances, such as
unreliable links or specific behavioral problems with certain clients. and authentication servers
Example
The following command sets the number of seconds that the device waits for a response to an EAP-request/
identity frame, to 3600 seconds.
dot1x max-req
The dot1x max-req Interface Configuration mode command sets the maximum number of times that the device
sends an Extensible Authentication Protocol (EAP)-request/identity frame (assuming that no response is
received) to the client, before restarting the authentication process. Use the no form of this command to return to
the default configuration.
Syntax
dot1x max-req count
no dot1x max-req
Parameters
•
count — Number of times that the device sends an EAP-request/identity frame before restarting the
authentication process. (Range: 1-10)
Default Configuration
The default number of times is 2.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust for unusual circumstances, such as
unreliable links or specific behavioral problems with certain clients. and authentication servers
Example
The following example sets the number of times that the device sends an EAP-request/identity frame to 6 .
dot1x timeout supp-timeout
The dot1x timeout supp-timeout Interface Configuration mode command sets the time for the retransmission of
an Extensible Authentication Protocol (EAP)-request frame to the client. Use the no form of this command to
return to the default configuration.
Console(config)# interface ethernet 1/g16
Console(config-if)# dot1x timeout tx-period 3600
Console(config)# interface ethernet 1/g16
Console(config-if)# dot1x max-req 6