Allied Telesis AT-S95 CLI - Manual (Page 44)

Page 32
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
Example
The following example displays the local users configured with access to the system.
The following table describes significant fields shown above.
enable password
The enable password Global Configuration mode command sets a local password to control access to user and
privilege levels. Use the no form of this command to remove the password requirement.
Syntax
enable password [level level] password [encrypted]
no enable password [level level]
Parameters
•
password — Password for this level. (Range: 1-159 characters)
• level level — Level for which the password applies. If not specified the level is 15. (Range: 1-15)
• encrypted — Encrypted password entered, copied from another device configuration.
Default Configuration
No enable password is defined.
Command Mode
Global Configuration mode
Console# show users accounts
Username Privilege Password
Aging Password Expiry
date Lockout
-------- --------- -------- ----------- -------
Bob 1 120 Jan 21 2005 -
Admin 15 120 Jan 21 2005 -
Manager 15 120 Jan 21 2005 -
Field Description
Username Name of the user.
Privilege User’s privilege level.
Password Aging User’s password expiration time in days.
Password Expiry Date Expiration date of the user’s password.
Lockout If lockout control is enabled, specifies the number of failed authentication attempts
since the user last logged in successfully. If the user account is locked, specifies
LOCKOUT.