Allied Telesis AT-S95 CLI - Manual (Page 168)

Page 156
Not approved by Document Control. For review only.
Allied Telesis
Command Line Interface User’s Guide
show ports monitor
The show ports monitor User EXEC mode command displays the port monitoring status.
Syntax
show ports monitor
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how the port monitoring status is displayed.
Console show ports monitor
Source Port
Destination Port Type Status
----------- ---------------- ----- -------
1/g1 1/g8 RX,TX Active
1/g2 1/g8 RX,TX Active
1/g18 1/g8 RX Active